Printronix SL4M - Manual (Page 142)

142
Chapter 4 CONFIGURATION MENU
CONFIGURATION Submenus
Save Config
This option allows you to save up to eight unique configurations to meet
different print job requirements. This eliminates the need to change the
parameter settings for each new job. The configurations are stored in memory
and will not be lost if you turn off the printer. If the Protect Configs. parameter
is enabled, the new configuration will not be saved unless the existing
configuration has been deleted first. The Factory default configuration cannot
be changed and saved under the Factory menu, but can be changed and
saved as one of the eight unique configurations. See “Saving a Configuration”
on page 148 for details.
The factory default is Cfg 1.
Load Config
The printer can store up to eight configurations in memory. This parameter
allows you to select and load a specific configuration.
The options are 1 to 8 and Factory. The factory default is Factory.
Print Config
This option is used to print a listing of various stored printer configurations.
We recommend you store printouts of your configurations in a safe place for
quick referral.
The options are Current (factory default), Factory, Power-Up, All, and 1 to 8.
Delete Config
You can delete one or all of your eight customized configurations. The factory
default configuration cannot be deleted. The All selection deletes all
previously saved configurations except for the factory default configuration.
The factory default is All.
Power-Up Config
You can specify any one of nine configurations (1-8 saved custom
configurations or Factory) as the power-up configuration.
The factory default is Factory.
Protect Config
You can specify whether or not a new configuration should overwrite an
existing configuration when you activate the Save Configs. parameter. When
disabled (factory default), the new configuration will overwrite the existing
configuration. When enabled, the new configuration will
not overwrite the
existing configuration, and the message “CONFIG. EXISTS / Delete First”
displays.
The factory default is Disable.