Printronix SL4M User Manual
Page 33
Advertising
Loading Fanfold Media
33
12. Close the pivoting deck by rotating the deck lock lever fully clockwise.
IMPORTANT
Ensure the pivoting deck is down and locked before attempting to
advance media or print. Failure to do so will cause the “PRINT HEAD UP
Close Print Head” fault message to display.
13. Verify that Print Mode submenu is set for the media type installed (direct
or transfer). The Print Mode submenu is located in the MEDIA SETUP
menu. See “Main Menu” on page 66 for more information. Also, if thermal
transfer media is installed, see “Loading Ribbon” on page 22.
14. Verify the Gap/Mark Sensor selection matches the type of media
installed. See “Sensing Different Media Types” on page 46.
Deck Lock
Lever
Pivoting Deck
Advertising