Printronix SL4M - Manual (Page 197)

Fault Messages
197
BAD NVM CALL 1
BAD NVM CALL 2
BAD NVM CALL 3
BAD NVM CALL 4
BAD NVM CALL A Yes Printer firmware code
error. 1. Cycle power.
2. If the problem persists,
follow the instructions on
page 186 and contact
your authorized
customer service
representative.
BAD VFU CHANNEL Yes The user tried to use an
undefined VFU
channel. Use defined channels.
CALIBRATION FAIL
See User Manual
Yes Calibration values
derived from Manual
Calibrate were not
acceptable. Perform a Run Manual Cal
(run manual calibrate) again.
CANNOT CALIBRATE
Disable Peel-Off
Yes Run Auto-Calibrate was
attempted with Peel-Off
Media Handling
selected.
NOTE: You can
perform Auto Calibrate
in Peel-Off mode if Cal
in Peel Mode = Enable.
Be prepared to catch
labels during Run
Auto-Calibrate.
1. Select another Media
Handling option in the
MEDIA SETUP menu.
2. Enable Cal in Peel Mode
in the SENSOR SETUP
menu.
NOTE: Admin User must
= Enable in the
PRINTER SETUP menu.
CARTRIDGE REMOVED
Check Cartridge
Yes The cartridge was
removed while the
printer was powered
on. 1. Power off the printer.
2. Install the cartridge.
3. Power on the printer.
Copy Complete
Run Auto-Cal
After Reboot Yes The QCMC has
finished copying to the
printer. Wait for the printer to reboot,
then Run Auto-Cal under the
Sensor Setup menu.
Table 15. Fault Messages
Displayed Message
Can User
Correct?
Explanation Solution