Printronix SL4M - Manual (Page 104)

104
Chapter 4 EMULATION MENU
User-Def Ratio
This option allows you to ignore the user-defined barcode ratio and replace it
with the default ratio (X1).
• Enable (factory default). Allows the user-defined barcode ratio.
• Disable . The user-defined barcode ratio will be replaced with the default
ratio (X1).
Lead PDF Dist
Adjusts the leading and trailing character spacing distance of the PDF for
UPC/EAN barcodes.
The range is 0.01- 0.10 inches in 0.01 inch increments, and the factory default
is 0.10 inches.
Trunc Dyn Data
This submenu allows the user to truncate the dynamic data up to the
maximum data length specified in Create Mode.
• Disable (factory default). If the dynamic data exceeds the maximum data
length, an error will report.
• Enable . If the dynamic data exceeds the maximum data length, the data
truncates.
Vertical Adjust
This option is to adjust printer dpi to expand or shrink the vertical position of
graphic elements and the height of the vertical line. The factory default is 0
dots. The adjustment range is from -20 dots to 20 dots with respect to the
current printer dpi.
Boundary Check
This option turns on or off the page boundary check for all print elements.
• Enable (factory default). When enabled, an out of bound error is reported
if the print element is out of the page boundary.
• Disabled . When disabled, no out of bound error is reported. The out of
bound print element prints over the page boundary.
Repeat Form Opt
• Enable (factory default). Speeds up the processing of repeated forms for
PGL, thereby resulting in increased printer throughput. This option
provides no speed benefit for forms that are unrelated to one another and
should be disabled under those circumstances.
• Disable . Should be selected when subsequent forms are unrelated to
one another.