Printronix SL4M User Manual
Page 216
216
Chapter
6
Diagnostics for E0xx, Bad NVM, or ILL NVM Errors
DO NOT POWER OFF
N/A
This is a standard
warning message that
displays while the
printer is downloading
software.
Do not power off the
printer until
downloading is
complete.
ETHERNET
INITIALIZING
Please Wait
N/A
Ethernet is initializing.
No action is required.
ETHERNET READY
N/A
Ethernet Interface has
finished initializing.
No action is required.
ETHERNET
RESETTING
Please Wait
N/A
Ethernet Interface is
being reset.
No action is required.
LOADING PROGRAM
INTO FLASH
Please Wait
N/A
Expanded Flash
Cartridge download
mode only.
No action is required.
POWER SAVER MODE
N/A
This is a status
message. The printer is
in low-energy idle state,
the higher voltages are
off, the front panel is
dimmed, and only
+5Vdc logic circuits are
active.
No action required.
Sending a print job or
pressing any control
panel key turns off
power saver mode.
PRINTER RESETTING
Please Wait
N/A
Printer finished loading
the program into flash
memory and is
automatically resetting
itself.
No action is required.
RESTORING
BOOT CODE
Yes
Normal download
initialization message.
No action required.
SDRAM TEST 32MB
N/A
Status only not an error.
No action is required.
STATUS:
LOADING FIRMWARE
Please Wait
N/A
Normal message when
the printer is powered
up while holding down
both the
(Menu) and
the Down keys in
preparation to
download software to
the printer.
Complete the
downloading
software procedure.
Table 16. Status Messages
Displayed Message
Can User
Correct?
Explanation
Solution