Printronix SL4M - Manual (Page 124)

124
Chapter 4 INTERFACES Menu
• Job Control
• Standard (factory default). The NIC waits for the entire job to be
received before it indicates the job is done.
• Enhanced . The NIC waits for the entire job to be printed before it
indicates the job is done.
• Fast Standard . The EOJ (End of Job) packet is acknowledged
immediately. Use this option if the job is timed out due to a delay in
the acknowledgement of the EOJ packet because of the amount of
data being printed.
• Off . There is no synchronization between the NIC and the printer.
NOTE: For detailed information about using the NIC, refer to the Network
Interface Card User’s Manual.
• Offline Process
• Disable (factory default). When set to disable, the printer does not
process parallel/network data while offline.
• Enable . When set to enable, the printer continues to process (but not
print) the current network/parallel job while the printer is offline until
the printer's buffer is full.
WLAN SETTING
• IP Address . This item allows you to set the IP Address for the TCP/IP
protocol in four three-digit segments (SEG1 through SEG4). If the IP
Address is assigned by BootP, ARP or DHCP, it is dynamic and read-
only.
The defaults for the SEG1 through SEG4 are 000, 000, 000, and 000.
After specifying an IP address, you are prompted to:
Press
↵
to Save & Exit
Press to Exit
Press to Edit.
NOTE: When changing the IP Address, the printer resets the Network
Interface Card (NIC) when the printer is placed online. When the
printer resets the NIC, the LCD displays DO NOT POWER OFF. The
printer will then reboot to re-establish communication with the NIC.