Printronix SL4M - Manual (Page 109)

PRINTER SETUP Submenus
109
PTX Setup Parse
• Enable (factory default). Will parse and execute the PTX SETUP
commands.
• Ignore . Will parse the PTX SETUP commands but not act on them.
• Disable . Will not parse the PTX SETUP commands so they will print out
as text.
PTX Setup SFCC
Allows you to choose the hex value of the ASCII character you wish to use as
the SFCC for the PTX SETUP command. Valid hex values are 01-FF.
The factory default value is hex 21, which corresponds to the “!” character.
PJL Control
• Disable (factory default). Will not parse the PJL commands; they will not
print out as text.
• Enable . Will parse and execute the PJL commands.
Cancel Key
• Enable (factory default). When enabled, the  key may be used in
offline mode to clear all data in the print buffer, and deleted data will not
be printed.
• Disable .
Rcv. Status Port
This option defines the interface being used to receive the emulation status
command.
• Automatic (factory default). When selected, the status command is sent
to the printer with the print data through the active host interface.
• Serial . When selected, the status command is sent to the printer through
the serial interface regardless of the active host interface.
Ret. Status Port
This option selects the port for the Return Status Commands (i.e., ~STATUS
(PGL) and ~HS (ZGL)) to send the status data back to the Host.
The options are Automatic (factory default), Disable, E-NET Data Port, Serial,
E-NET Stat Port, USB, and IEEE 1284.
Automatic uses the currently active host port. However, if in AutoSwitching
mode and no port is currently active, Automatic will use the last active port.