Asus GigaX3124 - Manual (Page 235)

GigaX3124 Layer3 Switch CLI Command Reference
210
Default The default is auto.
Description Use the spanning-tree edge-port configuration command on
the switch stack or standalone switch to set the spanning-tree
interface attached to a LAN segment that is at the end or not.
Example ASUS(config-if)# spanning-tree edge-port enable
17.11 spanning-tree forward-time <4-30>
Syntax spanning-tree forward-time <4-30>
Parameters <4-30> Forward time value, in seconds
Command Mode Global configuration mode
No/clear
no spanning-tree forward-time
Show show spanning-tree summary
Default 15 sec
Description Use the spanning-tree forward-time configuration command on
the switch stack or standalone switch to set the spanning-tree
bridge forward delay time (sec).
Example ASUS(config)# spanning-tree forward-time 20
17.12 spanning-tree hello-time <1-10>
Syntax spanning-tree hello-time <1-10>
Parameters <1-10> Hello time value, in seconds
Command Mode Global configuration mode
No/clear
no spanning-tree hello time
Show show spanning-tree summary
Default 2 sec
Description Use the spanning-tree hell-time configuration command on the
switch stack or standalone switch to set the hello time to send
hello BPDUs.
Example ASUS(config)# spanning-tree hello time 3