Asus GigaX3124 - Manual (Page 325)

GigaX3124 Layer3 Switch CLI Command Reference
300
26.3 standby <1-255> (preempt|nonpreempt)
Syntax standby <1-255> (preempt|nonpreempt)
Parameters preempt Preemption mode, default value
nonpreempt Non-preemption mode
Command Mode Interface configuration mode
No/clear
no standby <1-255> nonpreempt
Show show standby [IFNAME]
Default The default mode is preempt
Description Use the command to set the specified virtual router as preempt
or nonpreempt mode. It must enable the virtual router first.
Example ASUS(config)# standby 1 nonpreempt
26.4 standby <1-255> priority <1-254>
Syntax standby <1-255> priority <1-254>
Parameters <1-254> Priority parameter, 100 is default value
Command Mode Interface configuration mode
No/clear
no standby <1-255> priority
Show show standby [IFNAME]
Default The default value is 100
Description Use the command to set the priority value of the specified virtual
router. The value is used to elect VRRP master.
Example ASUS(config)# standby 1 priority 200
26.5 standby <1-255> timers <1-1000>
Syntax standby <1-255> timers <1-1000>
Parameters <1-1000> Advertisement interval parameter, seconds
Command Mode Interface configuration mode
No/clear
no standby <1-255> timers
Show show standby [IFNAME]