Asus GigaX3124 - Manual (Page 32)

GigaX3124 Layer3 Switch CLI Command Reference
7
1.2 Command-Line Error Messages
Table 1-2 lists some error messages that you might encounter while using the
CLI.
Table 1-2: Common CLI Error Messages
Error Message Meaning How to Get Help
Ambiguous
Command. You did not enter enough
characters for your
switch to recognize
the command.
Reenter the command followed by
a space and a question mark (?).
The possible keywords that you can
enter with the command appear.
Command
incomplete.
You did not enter all of
the keywords or values
required by this command.
Reenter the command followed by
a space and a question mark (?).
The possible keywords that you can
enter with the command appear.
Unknown
command.
You entered the
command incorrectly.
Enter a question mark (?) to display
all of the commands that are
available in this command mode.
The possible keywords that you can
enter with the command appear.
1.3 Accessing the CLI
The following procedure assumes you have already assigned IP information and
password to the switch or command switch. You can assign this information to
the switch in the following ways:
• Using the setup program, as described in the release notes
• Manually assigning an IP address and password
To access the CLI, follow these steps:
Step 1 Start up the emulation software (such as ProComm, HyperTerminal, tip,
or minicom) on the management station.
Step 2 If necessary, reconfigure the terminal-emulation software to match the
switch console port settings (default settings are 9600 baud, no parity, 8 data
bits, and 1 stop bit).