Asus GigaX3124 - Manual (Page 58)

GigaX3124 Layer3 Switch CLI Command Reference
33
Show show running-config
Default
Description
This command sets the ip address for indicated L3 interface.
Examples ASUS(config)# interface vlan2
ASUS(config-if)# ip address 192.192.1.11/24
3.11 line loopback
Syntax line loopback
Parameters
Command Mode Interface configuration mode
No/clear
no line loopback
Show show running-config
Default Enable
Description Use the line loopback command on the switch stack or stand-
alone switch to detect loopback of the port.
Examples ASUS(config-if)# line loopback
ASUS(config-if)# no line loopback
3.12 line loopback shutdown <60-600>
Syntax line loopback shutdown <60-600>
Parameters shutdown Interface maximum shutdown time
<60-600> Showdown time, in seconds
Command Mode Interface configuration mode
No/clear
no line loopback shoutdown
Show show running-config
Default Shutdown forever.
Description To set the line loopback shutdown time for the dedicated port.
Examples ASUS(config-if)# line loopback shutdown 60