Mapping cos values to acls, Mapping cos values to acls -134, G cos values to acls – Asus GigaX2024SX User Manual
Page 159: Mappin
Note: Mapping specific values for IP Port Priority is implemented as an interface
ration command, but any changes will apply to the all interfaces on the
g CoS Values to ACLs
Use the ACL CoS Mapping page to set the output queue for packets matching an
ACL rule as shown in the following table. Note that the specified CoS value is only
configu
switch.
Mappin
used to map the matching packet to an output queue; it is not written to the packet
itself. For information on mapping the CoS values to output queues, see page
3-170.
Command Attributes
• Port – Port identifier.
• Name* – Name of ACL.
• Type – Type of ACL (IP or MAC).
ity – CoS value used for packets matching an IP ACL rule. (Range:
• CoS Prior
0-7)
For information on configuring ACLs, see page 3-77.
lick Priority, ACL CoS Priority. Enable mapping for any port, select an
Web – C
ACLfrom the scroll-down list, then click Add.
3-134