Asus GigaX2024SX - Manual (Page 278)

• 100full - Forces 100 Mbps full-duplex operation
full-duplex operation
lf - Forces 10 Mbps half-duplex operation
D
by default.
When auto-negotiation is disabled, the default speed-duplex setting is 100half
Interface Configuration (Ethernet, Port Channel)
• To force operation to the speed and duplex mode specified in a speed-duplex
no negotiation command to disable auto-negotiation on
ing example configures port 5 to 100 Mbps, half-duplex operation.
• 100half - Forces 100 Mbps half-duplex operation
• 10full - Forces 10 Mbps
• 10ha
efault Setting
• Auto-negotiation is enabled
•
for 100BASE-TX ports and 1000full for Gigabit Ethernet ports.
Command Mode
Command Usage
command, use the
the selected interface.
• When using the negotiation command to enable auto-negotiation, the
optimal settings will be determined by the capabilities command. To set the
speed/duplex mode under auto-negotiation, the required mode must be
specified in the capabilities list for an interface.
Example
The follow
Related Commands
egotiation (4-148)
es (4-149)
n
This command enables autonegotiation for a given interface. Use the
E
tion (Ethernet, Port Channel)
tiation is enabled the switch will neg
l configuration will also
n
capabiliti
egotiation
no form to
disable autonegotiation.
Syntax
[no] negotiation
Default Setting
nabled
C
Interface Configura ommand Mode
Com
• When auto-nego
mand Usage
otiate the best settings for
a link based on the capabilities command. When auto-negotiation is disabled,
you must manually specify the link attributes with the speed-duplex and
flowcontrol commands.
• If autonegotiation is disabled, auto-MDI/MDI-X pin signa
be disabled for the RJ-45 ports.
4-110