Asus GigaX2024SX - Manual (Page 186)

Command Mode
Line Configuration
h as terminals and modems
rity bit setting.
cify no parity, enter this command:
Command Usage
Communication protocols provided by devices suc
often require a specific pa
Example
To spe
s
ets both the
(from terminal) speeds. Use the no form to
ing.
sp
n
its per second.
Line Configuration
Co
tem indicates if the speed you selected is not supported. If
n, the switch will automatically detect the baud rate
d terminal, and adjust the speed accordingly.
peed
and sets the terminal line’s baud rate. This command s This comm
transmit (to terminal) and receive
restore the default sett
Syntax
eed bps
o speed
rate in b bps - Baud
(Options: 9600, 19200, 38400, 57600, 115200 bps, or auto)
Default Setting
9600
Command Mode
mmand Usage
match the baud rate of the device connected to the serial Set the speed to
port. Some baud rates available on devices connected to the port might not be
supported. The sys
you select the “auto” optio
tache configured on the at
Example
57600 bps, enter this command: To specify
stopbits
This command set
form s the number of the stop bits transmitted per byte. Use the no
to restore the default setting.
Syntax
stopbits {1 | 2}
• 1 - One stop bit
• 2 - Two stop bits
4-18