Asus GigaX2024SX - Manual (Page 43)

Figure 3-10. Deleting Files
CLI – To download new firmware form a TFTP server, enter the IP address of the
TFTP server, select “opcode” as the file type, then enter the source and
destination file names. When the file has completed the download, set the new file
to start up the system and then restart the switch.
To start the new firmware, enter the “reload” command or reboot the system.
Saving or Restoring Configuration Settings
les to and from switch units in a stack. The configuration files can be later
ommand Attributes
- file to running-config – Copies a file in the switch to the running configuration.
- file to startu
uration.
o tftp – Copies the running configuration to a TFTP server.
- startup-config to file – Copies the startup configuration to a file on the switch.
- startup-config to running-config – Copies the startup config to the running config.
- startup-config to tftp – Copies the startup configuration to a TFTP server.
- tftp to file – Copies a file from a TFTP server to the switch.
- tftp to running-config – Copies a file from a TFTP server to the running config.
- tftp to startup-config – Copies a file from a TFTP server to the startup config.
- file to unit – Copies a file from this switch to another unit in the stack.
another unit in the stack to this switch.
the leading letter
You can upload/download configuration settings to/from a TFTP server or copy
fi
downloaded to restore the switch’s settings.
C
• File Transfer Method – The configuration copy operation includes these options:
- file to file – Copies a file within the switch directory, assigning it a new name.
p-config – Copies a file in the switch to the startup config
- file to tftp – Copies a file from the switch to a TFTP server.
- running-config to file – Copies the running configuration to a file.
- running-config to startup-config – Copies the running config to the startup config.
- running-config t
- unit to file – Copies a file from
• TFTP Server IP Address – The IP address of a TFTP server.
• File Type – Specify config (configuration) to copy configuration settings.
• File Name — The file name should not contain slashes (\ or /),
3-18