Asus GigaX2024SX - Manual (Page 309)

The following example configures the switch to use Rapid Spanning Tree:
s
nfigures the spanning tree bridge forward time globally for this
form to restore the default.
-time seconds
y device must receive information about topology changes
addition, each port needs time to listen for
co iscarding state; otherwise,
panning-tree forward-time
This o command c
switch. Use the no
Syntax
rward spanning-tree fo
no spanning-tree forward-time
seconds - Time in seconds. (Range: 4-30 seconds)
The minimum value is the higher of 4 or [(max-age / 2) + 1].
Default Setting
15 seconds
Command Mode
Global Configuration
Usage Command
This command sets the maximum time (in seconds) the root device will wait
b fore changing states (i.e., discarding to learning to forwarding). This delay is
e
required because ever
before it starts to forward frames. In
nflicting information that would make it return to the d
mporary data loops might result. te
Example
s
This r this
swit default.
Syn
hello-time time
no spanning-tree hello-time
tim (Range: 1-10 seconds).
ue is the lower of 10 or [(max-age / 2) -1].
nds
Global Configuration
Command Usage
This command sets the time interval (in seconds) at which the root devic e trans
panning-tree hello-time
command configures the spanning tree bridge hello time globally fo
ch.Use the no form to restore the
tax
spanning-tree
e - Time in seconds.
The maximum val
Default Setting
2 seco
Command Mode
4-141