Asus GigaX2024SX - Manual (Page 20)

on page 4-1. For a list of all the CLI commands and detailed information on using
h’s onboard agent via a network connection, you must
first configure it with a valid IP address, subnet mask, and default gateway using a
console connection, DHCP or BOOTP protocol.
ss assignment via DHCP or BOOTP, see
etting an IP Address” on page 2-4.
switch supports four concurrent Telnet sessions.
ere within the attached network. The onboard
using Telnet from any computer attached
vigator 6.2 or above), or
full range of SNMP management functions, you must use
SNMP-based network management software.
eters, you must access the CLI at the
he “User Access
the CLI, refer to “Command Groups” on page 4-9.
Remote Connections
Prior to accessing the switc
The IP address for this switch is unassigned by default. To manually configure this
address or enable dynamic addre
“S
Note: This
After configuring the switch’s IP parameters, you can access the onboard
configuration program from anywh
configuration program can be accessed
to the network. The switch can also be managed by any computer using a web
browser (Internet Explorer 5.0 or above, or Netscape Na
from a network computer using SNMP network management software.
Note: The onboard program only provides access to basic configuration functions.
To access the
Basic Configuration
Console Connection
The CLI program provides two different command levels — normal access level
(Normal Exec) and privileged access level (Privileged Exec). The commands
available at the Normal Exec level are a limited subset of those available at the
Privileged Exec level and allow you to only display information and use basic
utilities. To fully configure the switch param
Privileged Exec level.
Access to both CLI levels are controlled by user names and passwords. The
switch has a default user name and password for each level. To log into the CLI at
the Privileged Exec level using the default user name and password, perform
hese steps: t
1. To initiate your console connection, press <Enter>. T
Verification” procedure starts.
2-3