Asus GigaX2024SX - Manual (Page 38)

Setting the Switch’s IP Address
This section describes how to configure an IP interface for management access
o
e with
ateway between the
obtain an
ist of four
e this format will
rt belonging to any VLAN, as long as
Host Configuration Protocol (DHCP), or Boot
not function until a reply
as been received from the server. Requests will be broadcast periodically by the
(Default: 0.0.0.0)
Subnet Mask – This mask identifies the host address bits used for routing to
Address – The physical layer address for this switch.
• Restart DHCP – Releases the current IP address and requests a new IP
address from the DHCP server.
over the network. The IP address for this switch is unassigned by default. T
manually configure an address, you need to change the switch’s default settings
(IP address 0.0.0.0 and netmask 255.0.0.0) to values that are compatibl
your network. You may also need to a establish a default g
switch and management stations that exist on another network segment.
You can manually configure a specific IP address, or direct the device to
address from a BOOTP or DHCP server. Valid IP addresses cons
decimal numbers, 0 to 255, separated by periods. Anything outsid
not be accepted by the CLI program.
Command Attributes
• Management VLAN – ID of the configured VLAN (1-4094, no leading zeroes).
By default, all ports on the switch are members of VLAN 1. However, the
management station can be attached to a po
that VLAN has been assigned an IP address.
• IP Address Mode – Specifies whether IP functionality is enabled via manual
configuration (Static), Dynamic
Protocol (BOOTP). If DHCP/BOOTP is enabled, IP will
h
switch for an IP address. (DHCP/BOOTP values can include the IP address,
subnet mask, and default gateway.)
• IP Address – Address of the VLAN interface that is allowed management
access. Valid IP addresses consist of four numbers, 0 to 255, separated by
periods.
•
specific subnets. (Default: 255.0.0.0)
• Gateway IP address – IP address of the gateway router between this device
and management stations that exist on other network segments. (Default: 0.0.0.0)
• MAC
3-13