Asus GigaX2024SX - Manual (Page 280)

R
negotiation (4-148)
sp
flo
This
[n
ntrol can eliminate frame loss by “blocking” traffic from end stations or
operation and IEEE 802.3x for full-duplex
operation.
• To force flow control on or off (with the flowcontrol or no flowcontrol
command), use the no negotiation command to disable auto-negotiation on
the selected interface.
• When using the negotiation command to enable auto-negotiation, the optimal
settings will be determined by the capabilities command. To enable flow
control under auto-negotiation, “flowcontrol” must be included in the capabilities
list for any port
• Avoid using flow control on a port connected to a hub unless it is actually
required to solve a problem. Otherwise back pressure jamming signals may
degrade overall performance for the segment attached to the hub.
Example
The following example enables flow control on port 5.
elated Commands
eed-duplex (4-147)
wcontrol (4-150)
flowcontrol
command enables flow control. Use the no form to disable flow control.
Syntax
o] flowcontrol
Default Setting
Flow control enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• Flow co
segments connected directly to the switch when its buffers fill. When enabled,
back pressure is used for half-duplex
Related Commands
negotiation (4-148)
capabilities (flowcontrol, symmetric) (4-149)
4-112