Asus GigaX2024SX - Manual (Page 281)

shutdown
This command disables an interface. To restart a disabled interface, use the no
form.
Syntax
[no] shutdown
Default Setting
All interfaces are enabled.
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
This command allows you to disable a port due to abnormal behavior (e.g.,
excessive collisions), and then reenable it after the problem has been resolved.
curity reasons. You may also want to disable a port for se
Example
The following example disables port 5.
s
ast storm control. Use the no form to disable
l.
e rate
(Range: 64-95232000)
Default Setting
Enabled for all ports
Packet-rate limit: 32000 octets per second
Command Mode
Interface Configuration (Ethernet)
Command Usage
• When broadcast traffic exceeds the specified threshold, octets above that
threshold are dropped.
• This command can enable or disable broadcast storm control for the selected
interface. However, the specified threshold value applies to all ports on the
switch.
Example
The following shows how to configure broadcast storm control at 600 octets per
second:
witchport broadcast packet-rate
This command configures broadc
broadcast storm co
Syn
ntro
tax
ort broadcast octet-rat switchp
no switchport broadcast
- Threshold level as a rate; i.e., octets per second. rate
4-113