Asus GigaX2024SX - Manual (Page 86)

Figure 3-38. Configuring MAC ACLs
CLI – This rule permits packets from any source MAC address to the destination
address 00-e0-29-94-34-de where the Ethernet type is 0800.
Binding a Port to an Access Control List
After configuring Access Control Lists (ACL), you should bind them to the ports
that need to filter traffic. You can only assign one IP access list and/or one MAC
access list to any port.but you can only assign one MAC access list to all the ports
on the switch.
Command Usage
• You must configure a mask for an ACL rule before you can bind it to
a port.
• This switch only supports ACLs for ingress filtering. You can only bind one IP
ACL to any port, and one MAC ACL globally, for ingress filtering.
Command Attributes
• Port – Fixed port or SFP module. (Range: 1-26)
• IP – Specifies the IP Access List to enable for a port.
• MAC – Specifies the MAC Access List to enable globally.
• IN – ACL for ingress packets.
• ACL Name – Name of the ACL.
3-61