Asus GigaX2024SX - Manual (Page 181)

There is no default line.
onfiguration
ty” in
g., databits) do not affect Telnet connections.
Command Mode
Global C
Command Usage
Telnet is considered a virtual terminal connection and will be shown as “V
screen displays such as show users. However, the serial communication
parameters (e.
Example
To enter console line mode, enter the following command:
Related Commands
w line (4-25)
form to disable
password checking and allow connections without a password.
no login
user
login local
Command Mode
Line Configuration
Command Usage
• There are three authentication modes provided by the switch itself at login:
- login selects authentication by a single global password as specified by the
password line configuration command. When using this method, the
management interface starts in Normal Exec (NE) mode.
- login local selects authentication via the user name and password specified by
the username command (i.e., default setting). When using this method, the
management interface starts in Normal Exec (NE) or Privileged Exec (PE) mode,
depending on the user’s privilege level (0 or 15 respectively).
- no login selects no authentication. When using this method, the management
interface starts in Normal Exec (NE) mode.
• This command controls login authentication via the switch itself. To configure
user names and passwords for remote authentication servers, you must use the
sho
show users (4-85)
login
T is command enables password checking at login. Use the no h
Syntax
login [local]
local - Selects local password checking. Authentication is based on the
name specified with the username command.
Default Setting
RADIUS or TACACS software installed on those servers.
Example
4-13