Address table commands, Mac-address-table static, Address table commands -135 – Asus GigaX2024SX User Manual
Page 303: Mac-address-table static -135
![background image](/manuals/299344/303/background.png)
Address Table Commands
These commands are used to configure the address table for filtering specified
addresses, displaying current entries, clearing the table, or setting the aging time.
mac-address-table static
his command maps a static address to a destination port in a VLAN. Use the no
ddress.
ntax
mac-address-table static mac-address interface interface
an-id [action]
no mac-address-table static mac-address vlan vlan-id
- MAC address.
•
ort
- u
ort number.
• vlan-id - VLAN ID (Range: 1-4094)
• action -
- delete-on-reset - Assignment lasts until the switch is reset.
T
form to remove an a
Sy
vlan vl
• mac-address
interface
• ethernet unit/p
nit - This is device 1.
- port - P
• port-channel channel-id (Range: 1-4)
- permanent - Assignment is permanent.
Default Setting
No static addresses are defined. The default mode is permanent.
4-135