Asus GigaX2024SX - Manual (Page 170)

Telnet Connection
ment, your
ent station and any network device you want to manage over the
. Valid IP addresses consist of four numbers,
ch address consists of a network portion and
.1, with
nsists of a network portion (10.1.0) and a host
ss for this switch is unassigned by default.
the switch through a Telnet session, you must first set the IP address
for the switch, and set the default gateway if you are managing the switch from a
different IP subnet. For example,
Telnet operates over the IP transport protocol. In this environ
managem
network must have a valid IP address
0 to 255, separated by periods. Ea
host portion. For example, the IP address assigned to this switch, 10.1.0
subnet mask 255.255.255.0, co
portion (1).
Note: The IP addre
To access
If your corporate network is connected to another network outside your office or to
the Internet, you need to apply for a registered IP address. However, if you are
attached to an isolated network, then you can use any IP address that matches
the
configure the switch with an IP address, you can open a Telnet session
e steps:
host, enter the Telnet command and the IP address of the
ill display
show that you are using privileged
access mode (i.e., Privileged Exec), or “Vty-n>” for the guest to show that you
cess mode (i.e., Normal Exec).where n indicates the number
the necessary commands to complete your desired tasks.
“quit” or “exit” command.
A
nd, the login screen displays:
network segment to which you are attached.
After you
by performing thes
1. From the remote
device you want to access.
2. At the prompt, enter the user name and system password. The CLI w
the “Vty-n#” prompt for the administrator to
are using normal ac
of current Telnet session.
3. Enter
4. When finished, exit the session with the
fter entering the Telnet comma
4-2