YSI P 700 IQ Analyzer - Manual (Page 29)

ba76133e01 09/2013 29
P 700 IQ
3.3.2.2 Installation on a rail
For installation on a rail, the RM rail mount bracket is required.
Assembling the bracket Proceed as follows to install the housing on the rail:
Fig. 3-7: Connecting the supporting pipes with the cross pipes
1 Press the plastic protective plugs (1) into the upper ends of both
square supporting pipes (2).
2 Connect both supporting pipes with each other using the two
square cross pipes (6). To do so, use the eight angle brackets (7)
and a total of twelve short M8 hexagon head screws with large
plain washers and locknuts.
ATTENTION
Make sure that the rail is sufficiently stable. With installa-
tion at an open air test site, make sure that the installa-
tion will also hold out against strong storms.
1
2
3 4