Gilderfluke&Co old Smart Brick Manual User Manual
Page 122
the Smpte Card) is a standard straight-through RJ-11 telephone
style connector.
c)
DMX-512: For use when receiving a DMX-512 data stream moni-
toring and/or modifying it, and then retransmitting it. This requires a
special DMX-512 cable for connections to the Togglodyte. This is
wired as follows:
DMX-512 In (Male 5 pin XLR)
DMX-512 Out (FM 5 pin XLR)
pin #
COLOR
SIGNAL NAME:
1
n/c
(left)
1)
WHITE:
signal ground
2
n/c
2)
BLACK:
- serial data in
3
n/c
3)
RED:
+ serial data in
n/c
2
4)
GREEN:
- serial data out
n/c
3
5)
YELLOW: + serial data out
n/c
1
(right)
6)
BLUE:
signal ground
2) Sequencer mode:
a)
Record/Play Sequencer:
Allows a single eight bit channel to be
recorded and played back repeatedly.
b) Two Phase Timer: Pulses all of the digital bits together.
c) Four Phase Timer: Pulses odd and even numbered bits alternate-
ly.
3) Numbering System: Allows you to select what type of numbering system
will be used on the Togglodyte.
a)
HEXadecimal (0-F)
b)
Decimal (0-9)
c)
Percentage (0-100%)
4)
Normal Encoder Prescaler: This allows you to set the divider used on the
analog input when manipulating any analog function. A larger divisor low-
ers the sensitivity of the analog input. Ten different rates between /1 to
/100 are available.
5)
Special Encoder Prescaler: This allows you to set the divider used on the
analog input when in Assign or Setup modes. A larger divisor lowers the
sensitivity of the analog input. Ten different rates between /1 to /100 are
available.
6)
Frame Rate: This is the update speed used when operating in J6 mode
(both of the other modes get their frame rate from the system to which
they are attached). Ten different frame rates are available from 20 to 200
Frames Per Second.
7)
Digital Name: This allows you to enable or disable the display of the
names of digital functions when operating in the PC¥MACs programming
Console mode. You can select whether: 1) none, 2) all the names within
an eight bit channel, or 3) only names of those bits which have been se-
lected will be displayed on the Togglodyte.
8)
Digital Number:
This allows you to toggle on and off whether the nu-
meric value for a digital port will be displayed.
9)
Analog Number:
This allows you to toggle on and off whether the nu-
meric value for a analog port will be displayed. Values of analogs beyond
eight bits can not be displayed in decimal mode, and will default to Hex
numeric values.
10) Timer A:
11) Timer B:
12) Timer C:
13) Timer D:
These allow you to modify the times used for the sequencer in
G
ILDERFLUKE
& C
O
.¥ 205 S. F
LOWER
S
T
.¥ B
URBANK
, CA 91502 ¥ 818/840-9484 ¥ 800/776-5972 ¥
FAX
818/840-9485
112 of 134