Gilderfluke&Co old Smart Brick Manual - Manual (Page 63)

¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥
Setup String Commands
ÒOÓ Setup String 1:
ÒPÓ Setup String 2:
ÒQÓ Setup String 3:
ÒRÓ Setup String 4:
ÒSÓ Setup String 5:
ÒTÓ Setup String 6:
ÒUÓ Setup String 7:
ÒVÓ Setup String 8:
ÒWÓ Setup String 9:
These commands are used to setup the strings which are sent out at the starts and ends of shows.
These strings can contain ASCII characters which are sent to and received from the serial port, as well as
special characters which can close the STOP, PLAY and REWIND relay outputs, send the search string for
a LaserDisk player, or cause the Brick Brain to wait until it receives an input on the BLUE, GREEN or PB in-
puts, or a character from the serial port before continuing.
Full details on the Start and End Strings can be found in the next section of the manual.
G ILDERFLUKE & C O .¥ 205 S. F LOWER S T .¥ B URBANK , CA 91502 ¥ 818/840-9484 ¥ 800/776-5972 ¥ FAX 818/840-9485
53 of 134