Smart brick configuration, 6264lp ram – Gilderfluke&Co old Smart Brick Manual User Manual
Page 22
- Smart Brick Configuration -
The majority of the configuration for the Smart Bricks is handled in the Brick Brain. The exceptions to
this are those jumpers which set the size and type of memory used in each Smart Brick, and whether or
not you would like the outputs from a Smart Brick to be disabled when ever the system is not advancing
frames.
The one jumper which the Smart Bricks have on them retain the same callout as are used in the nor-
mal Micro MACs Bricks. All configuration is done on JP-2. The two things which Smart Bricks must be con-
figured for are the memory size and type and the Ôenable/disable when stoppedÕ.
In all of the following drawings, the jumper pins are shown as circles contained within an outline of
the header assembly. Pins which are used for a given configuration are shown as filled-in, while those
which remain hollow are not being used. The jumper plugs (used for connecting adjacent pins)or wires
(used for connecting pins which are not adjacent) which connect the pins are shown as black lines. Any
pin which is shown filled in with black, but which does not have any wire or jumper plug shown on it,
must have all wires and/or jumper plugs removed from it in the actual Smart Brick you are configuring.
- 6264LP RAM -
To configure a Record/Playback Smart Brick for use with 6264LP static RAM Chips for a
capacity of 16,384 (16K) frames.
0
1
1
1
U
8
U
1
U
6
U
2
F
3
F
4
F
1
F
5
U
4
U
7
U
3
U
9
U
0
1
U
5
1
U
6
1
U
8
1
U
9
1
U
4
1
U
7
1
U
U 3
1
2
1
U
3
2
2
-
P
J
3
-
P
J
U2
channel
channel
channel
channel
LED
G
ILDERFLUKE
& C
O
.¥ 205 S. F
LOWER
S
T
.¥ B
URBANK
, CA 91502 ¥ 818/840-9484 ¥ 800/776-5972 ¥
FAX
818/840-9485
12 of 134