Gilderfluke&Co old Smart Brick Manual - Manual (Page 52)

If you ever need to set the Brick Brain back to its default settings (9600 baud and address 00H), you
can do so by powering down the card, and then turning on Dipswitch #7. When you power the card
back up, the default configuration setting will be reloaded. If you intend to change any of the settings to
anything other than the defaults, be sure to turn this switch back off before you power the card back
down. Otherwise, it will reload the default values right over any changes you have made when you
power the card back up.
G ILDERFLUKE & C O .¥ 205 S. F LOWER S T .¥ B URBANK , CA 91502 ¥ 818/840-9484 ¥ 800/776-5972 ¥ FAX 818/840-9485
42 of 134