Gilderfluke&Co old Smart Brick Manual - Manual (Page 35)

By adding a pushbutton switch to the connections shown above, you can make an easier to use
programming console that has a separate Ôprogramming enableÕ switch and pushbutton for turning on
and off the output
+15V
from brick output
momentary
programing
s w i t c h
to brick input
to show
rec.
play
SPDT
s w i t c h
For building an analog programming console, we recommend you use our Analog to Digital (A/D)
Converters. One is used for each analog function on your console. In this case the wires Ôfrom brick out-
putÕ, Ôto brick inputÕ, and Ôto showÕ are actually eight wires (plus ground and + supply) that make up a 1/4
J-6 cable:
potentiometer
r ecor d anal og
pl ayback
f r om br i ck out put t o br i ck i nput
t o show
SPST
sw i t ch
A/ D
G ILDERFLUKE & C O .¥ 205 S. F LOWER S T .¥ B URBANK , CA 91502 ¥ 818/840-9484 ¥ 800/776-5972 ¥ FAX 818/840-9485
25 of 134