IAI America XSEL-KX - Manual (Page 26)

10
Part 1 Installation
[1] FG terminal This terminal is used to ground FG on the enclosure. With a general-
purpose type, the enclosure is connected to PE in the AC input part inside
the controller.
With a compact type, FG and PE are not connected inside the controller.
Be sure to ground the FG terminal.
FG Terminal Specifications
Item Overview
M4 3-point SEMS screw, 5 mm
Cable size 2.0 ~ 5.5 mm
2
Grounding method Class D grounding
[2] Fuse holder (general-
purpose type only)
This half-cut fuse holder is used to protect overcurrent in the AC input
part. It prevents inflow of abnormal current generated by ground fault, etc.,
and uses a slow-blow fuse specified by IAI.
Overview of Fuse Holder Specifications
Item Description
Holder F-22001-A1 by Sato Parts
Fuse type TWO 250V20A by Fuji Terminal
Melting
characteristics
Slow-blow
* With a compact type, the fuse holder is mounted on the board. Type:
FGMT5 AC250V10A by Fuji Terminal
[3] AC input connector 200-VAC, single-phase input connector.
AC Power Connector Specifications
Item Overview
Connector name POWER
Connector GMSTB2.5/3-STF-7.62 by Phoenix Contact
3-pin, 2-piece connector
Supported cable size 1.25 ~ 2.5 mm
2
(AWG12 ~ 16)
Connected to AC power source
Terminal
assignments
1 In N AC power input, N side
2 In L AC power input, L side
3 PE (Protective grounding line)
*