IAI America XSEL-KX - Manual (Page 315)

299
Appendix
I/O Parameters
No. Parameter name
Default value
(Reference)
Input range Unit Remarks
124 Network attribute 5 0H 0H ~
FFFFFFFFH
Ethernet TCP/IP message communication attribute
Ethernet client/server type
(0: Not in use
1: Client (Automatic assignment of own port
number)
(2: Client (Specification of own port number)
→ This setting is not recommended because
of device limitations, such as an error
generation when the port is opened for
approx. 10 minutes after disablement of
close response check due to a power
failure at the connection destination, etc.)
3: Server (Specification of own port number))
* Note: Number of clients that can be
connected simultaneously to one
server port channel = 1
Bits 0 to 3: IAI protocol B/TCP (MANU
mode)
* PC software can be connected only in the
case of a client.
Bits 4 to 7: IAI protocol B/TCP (AUTO mode)
* PC software can be connected only in the
case of a client.
Bits 8 to 11: Channel 31 opened to user
Bits 12 to 15: Channel 32 opened to user
Bits 16 to 19: Channel 33 opened to user
Bits 20 to 23: Channel 34 opened to user
* If the parameter settings for own port number,
client/server type, IP address of connection
destination and port number of connection
destination do not match completely in the IAI
protocol B/TCP MANU or AUTO mode, the
connection will be cut off when the MANU/AUTO
mode is switched.
125 Network attribute 6 1E32H 0H ~
FFFFFFFFH
Bits 0 to 7: Module-initialization check timer
setting when Ethernet is used (100
msec)
Bits 8 to 15: Module-initialization check timer
setting when Ethernet is not used
(100 msec)
Bits 16 to 23: Increment of "PC/TP reconnection
delay time upon software reset"
when Ethernet is used (sec)
126 Network attribute 7 7D007D0H 0H ~
FFFFFFFFH
Ethernet TCP/IP message communication attribute
Bits 0 to 15: Min timeout value (msec)
Bits 16 to 31: Mout timeout value (msec)
127 Network attribute 8 5050214H 0H ~
FFFFFFFFH
Ethernet TCP/IP message communication attribute
Bits 0 to 7: CONNECT_TIMEOUT
(Change is prohibited)
(Setting of “0” is prohibited) (sec)
Bits 8 to 15: Connection retry interval
(IAI protocol B/TCP) (sec)
Bits 16 to 23: Send timeout value (sec)
Bits 24 to 31: IAI protocol B-SIO non-
communication check timer setting
(sec)
(IAI protocol B/TCP connection
trigger)