IAI America IA-T-XA (ANSI standard CE mark agreement) - Manual (Page 111)

14-2. Editing of axis-specific parameters
The axis-specific parameter No. 7 soft limit + is set as axis No. 1 = 300 mm and axis No. 2 = 200
mm.
Select the F3 (Axis) key on the upper screen shown on the previous page.
Mode flow:
The cursor is located at the parameter No.
Enter 7 with the ten-key numeric pad and press the
return key.
The screen for editing the axis-specific parameter
No. 7 soft limit + is displayed. The cursor is located
at the parameter data.
Data input for axis No. 1
Set the parameter by axis or I/O board depending on
the parameter item.
(Axis-specific parameters, driver card parameters,
encoder parameters, I/O slot card parameters)
Check that the screen for editing the axis No. 1 is
displayed.
Enter 300000 and press the return key. (Unit: 0.001
mm)
Press the WRT key to transfer the parameter data to
the controller.
One transfer (WRT key) with the Teaching Box stores the data only on the current display
screen in memory. Therefore, it is required to input the parameter data and transfer it by
axis (device).
The untransferred data becomes invalid when the screen is changed.
Axis No. in editing
Initial values are
different depending
on the model
The function keys of F3 (Dev-) and F4
(Dev+) are used to change the axis No.
Note:
108