IAI America IA-T-XA (ANSI standard CE mark agreement) - Manual (Page 13)

㾃 Axis operation keys (1- to ALL-, 1+ to ALL+)
These keys operate each axis. The functions are as follows according to the operation mode:
Function
Operation mode
1- to 4-, ALL- 1+ to 4+, ALL+
JOG
It jogs (inches) the axis in the
coordinate minus direction. It jogs (inches) the axis in the
coordinate plus direction.
POSITION
MOVEMENT
It moves the axis to the currently
displayed position. (In the
continuous movement mode, it
decrements the position No. after
completion of movement.) It moves the axis to the currently
displayed position. (In the
continuous movement mode, it
increments the position No. after
completion of movement.)
SERVO ON/OFF It gives the servo OFF command. It gives the servo ON command.
HOME POSITION
RETURN
It gives the home position return command.
For axial operation, execute it for a single axis or all axes in one operation.
In any operation mode other than JOG, the mode moves to the JOG mode after one operation.
ƒ Such jog actions with the JOG button are also valid for any not-homed axes. However,
coordinate values in this case have no meaning. Therefore, be extremely careful about
interference with the stroke end.
ƒ If jog operation is performed to the axis in action under the operation-button-acceptable
condition, the operation of the applicable axis is aborted when the JOG operation button is
turned OFF. (The next operation starts, if any.)
Cautions
10