IAI America IA-T-XA (ANSI standard CE mark agreement) - Manual (Page 33)

Select the F1 (Edit) key on the Mode Selection
screen.
Select the F2 (Prog) key on the Edit mode screen.
Select the F1 (Mdfy) key on the Prog (program edit
and new creation) screen.
The screen changes to the Mdfy (program No. input
mode) screen. The cursor is located at the program
No. Press the return key to move the cursor to the
location of the step No.
* When the program’s data is already input,
overwrite it (the original data is lost) or select the
program No. with no data input. The program No. or
step No. over which the cursor is located can be
changed with the PAGE UP and PAGE DOWN keys.
In addition, pressing the return key after inputting a
numeric value with the ten-key numeric pad can
change the program No. or step No.
Number of all program steps
stored in the controller’s RAM
Program No. Step No.
Number of program steps stored in the
controller’s RAM for the selected program No.
30