IAI America IA-T-XA (ANSI standard CE mark agreement) - Manual (Page 61)

㽳 Inching operation
Set the inching distance (travel made every time the
JOG key is pressed once).
Enter a numeric value for Dis (inching distance) with
the ten-key numeric pad on the JVel screen. The
numeric input range is between 0.001 and 1.000
(unit: mm). Return to the Teac screen with the ESC
key to execute inching operation.
(The figure above indicates the case of
the 2-axis specification. Therefore, the
effective axis operation keys are 1+ 1- 2+
2-.)
Clicking the axis operation key once makes
1-inching distance movement.
Clicking any of +1 through +4 makes inching
movement in the coordinate plus direction, while
clicking any of -1 through
-4 makes inching
movement in the coordinate minus direction.
Pressing and holding the axis operation key changes
to jog operation. In approximately 1.6 seconds after
the axis operation key is pressed, inching operation
changes to jog operation and further continuing to
press the key changes the jog velocity per second as
follows:
1
ĺ10㸢30㸢50㸢100 mm/sec.
Inching distance: 0.1 mm
㽴 Manual movement under servo OFF
Press the EMERGENCY STOP button in a Teac
screen condition to turn off the servo.
Press the ESC key to return to the Teac screen.
Move the actuator to any given position manually.
58