IAI America SEP-PT - Manual (Page 111)

105
[1] Setting of Initial Settings (2-point/3-point Settings)
Follow the instruction below for the initial settings:
No. Operation Window Remarks
1 Touch Initial set in the MEC
MENU window.
2 In the case of the password
value except for “0000”, the
password input window is
displayed.
Input the password.
Touch .
The password has been set
to “5119” when the unit was
shipped from the factory.
The password can be set in
‘Password’ under
Environment Setting.
3 Touch the 2 position or
3 position .
Touch Menu to return to
MEC MENU window at the
beginning.
(Reference)
Setting before shipment
Stop position: 2 position
4 Select either Both OFF or
Both ON for the input signal
to ST0 and ST1 for the
positioning at the
intermediate point for 3-point
stop.
Touch Menu to return to
MEC MENU window at the
beginning.
(Reference)
Setting before shipment
Method to select
intermediate point: Both ON
5 Touch Not used when the
positioning operation is
required, and touch Use
when the pressing operation
is required. Touch Menu to return to
MEC MENU window at the
beginning.
(Reference)
Setting before shipment
Pressing function:
Not used
6 Touch YES. Touch NO to return to the
previous window.
7 Touch YES. Reboot the controller to
activate the settings.
Settings will not change until
a reboot is performed.
Touch NO to return to the
previous window.