IAI America SEP-PT - Manual (Page 84)

78
(Pushing fails Current)
Set whether if the current limitation value at the time when the pressing operation is performed,
but there is no work to be pressed, is regarded as the current in pressing operation or the
current in the stop operation.
When selecting the current in stop operation for ASEP/DSEP, and the pressing operation is
performed, but there is no work to be pressed, the setting will be the torque limitation of the
current limitation value in moving operation.
(Auto Servo OFF Delay Time)
Set the time period until the servo-motor is turned OFF automatically when the Energy-Saving
function is enabled.
(Stop Mode) Displayed in the case of using PSEP Controller
Set whether if the servo-motor is stopped with the full servo-motor control system or complete
stop operation without using the full servo-motor control system, when the actuator is stopped.
(Note)
In the case that the position data is not reloaded after this
parameter is changed, the change is not reflected.
(Default Positioning Current Limit) Displayed in the case of using PSEP Controller
Set the Current Limit Value when the positioning operation is stopped.