IAI America SEP-PT - Manual (Page 154)

148
(Pushing Fails Current)
Set whether if the current limitation value at the time when the pressing operation is performed,
but there is no work to be pressed, is regarded as the current in pressing operation or the
current in the stop operation.
(Auto Servo OFF Delay Time)
Set the time duration before the automatic motor power supply (automatic servo) off when the
energy saving function is turned active.
(Stop Mode) Displayed in the case of using PMEC Controller and ERC3
Set whether if the servo-motor is stopped with the full servo-motor control system or complete
stop operation without using the full servo-motor control system, when the actuator is stopped.
(Note)
In the case that the position data is not reloaded after this
parameter is changed, the change is not reflected.
(Default Positioning Current Limit) Displayed in the case of using PMEC Controller and ERC3
Set the Default Positioning when the positioning operation is stopped.