IAI America SEP-PT - Manual (Page 77)

71
[3] I/O Setup Operation Example
The operation procedure is described taking a specific example.
Example of Operation Mode (PIO Pattern) “0” (Standard Point-to-Point Movement): Perform
the following setting.
Operation Mode Single Solenoid
Use of STOP Command (*STP) Disable
Servo Control Enable
Output Signals OUT2 and OUT3 OUT2 HEND, OUT3
዆ALM
Home return AUTO(Home return operation started with the
power input)
Output Signal LS0(Backward Position Detection),
LS1(Forward Position Detection)
No. Operation Window Remarks
1 Touch Initial set in the
SEP-PT MENU window.
2 Set the Automatic
Servo-Motor OFF Delay
Time.
Touch the I/O set.
When MENU is touched, the
SEP-PT MENU window is
returned.
The password can be set in
‘Password’ in Parameter
Menu.
3 Input the password.
Touch the .
The password has been set
to “5119” when the unit was
shipped from the factory.
4 Touch the 0.
“Operation Pattern 0” will be
selected.
When MENU is touched, the
SEP-PT MENU window is
returned.
5 Touch the OK. Touching Back or Cancel
returns to the preceding
window.
When MENU is touched, the
SEP-PT MENU window is
returned.