Removing the printer module – ZOLL Propaq MD Rev A User Manual
Page 66
Advertising
C
HAPTER
3
D
ISASSEMBLY
P
ROCEDURES
62
9650-0807-01 Rev. A
Removing the Printer Module
Tools Required
•
#1 Phillips screwdriver with torque capability
Setup
•
This procedure should be conducted on a static mat.
•
Wear a wrist strap to ground during the procedure.
To reinstall the printer module, reverse the steps.
Printer Disassembly
1
Place the unit on the mat in a horizontal
position.
2
Open the printer housing and remove the
printer paper.
3
Place the unit screen down and remove the
three (3) screws outside the printer module
in the illustrated areas.
Note: During reassembly, torque screws to
6 in-lbs.
4
Slowly slide the printer from the unit, being
careful not to strain the cables.
5
Disconnect the two (2) cable connectors
from the printer module.
connectors
Advertising