ZOLL Propaq MD Rev A User Manual
Page 84
Advertising
C
HAPTER
3
D
ISASSEMBLY
P
ROCEDURES
80
9650-0807-01 Rev. A
11
Locate the black ferrite. Using the orange
stick, pull the ferrite cover apart and untwist
the couple.
12
Cut the tie wrap securing the Power
Monitor to Pace cable (black and red
coupled wire) and disconnect the cable (via
the red connector) in illustrated area.
13
Remove four (4) screws from the frame
support in the areas illustrated.
Note: During reassembly, torque screws to
6 in-lbs.
14
Remove red and white MFE cable (via the
white connector) from the ECG board in the
area illustrated.
ferrite
tie wrap
red connector
Advertising