Removing the front enclosure module – ZOLL Propaq MD Rev A User Manual
Page 70
Advertising
C
HAPTER
3
D
ISASSEMBLY
P
ROCEDURES
66
9650-0807-01 Rev. A
Removing the Front Enclosure Module
Tools Required
•
#2 Phillips screwdriver with torque capability
•
Wooden stick
Setup
•
This procedure should be conducted on a static mat.
•
Wear a wrist strap to ground during the procedure.
•
Complete these procedures in the following order before performing this procedure:
1.
“Removing the Handle” on page 61
2.
“Removing the Printer Module” on page 62
To reinstall the front enclosure module, reverse the steps.
Front Enclosure Disassembly
1
Remove tape from the top of the unit.
2
Separate monitor front enclosure.
3
Pivot top up with cables still connected.
4
Remove grounding screw as shown in the
illustration.
Note: During reassembly, torque screw to 6
in-lbs.
grounding
screw
Advertising