Removing the etco, And nibp modules – ZOLL Propaq MD Rev A User Manual
Page 75
Removing the EtCO2 and NIBP Modules
9650-0807-01 Rev. A
Propaq MD Service Manual
71
Removing the EtCO
2
and NIBP Modules
Tool Required
•
# 1 Phillips screwdriver with torque capability
•
Wooden stick
•
Large diagonal cutters
Setup
•
This procedure should be conducted on a static mat.
•
Wear a wrist strap to ground during the procedure.
•
Complete these procedures in the following order before performing this procedure:
1.
“Removing the Handle” on page 61
2.
“Removing the Printer Module” on page 62
3.
“Disassembling the Main Unit” on page 63
4.
“Removing the Front Enclosure Module” on page 66
To assemble the EtCO
2
and/or NIBP modules, reverse the steps.
EtCO
2
and/or NIBP Disassembly
1
Unplug the power connector (shown in
illustration).
Note: During reassembly, torque screws to
6 in-lbs.
2
Remove four (4) screws around the EtCO
2
unit.
Note: During reassembly, torque screws to
6 in-lbs.