ZOLL Propaq MD Rev A User Manual
Page 83
Advertising
Removing the Defibrillator Boards and Capacitor Bank Modules
9650-0807-01 Rev. A
Propaq MD Service Manual
79
5
Remove screw in the middle of the plastic
isolator (located on top of the processor
board) in the area illustrated.
Note: During reassembly, torque screw to 6
in-lbs.
6
Remove the plastic isolator shield.
7
Remove the four (4) screws from the
processor board in the areas illustrated.
Note: During reassembly, torque screws to
6 in-lbs.
8
Lift up the processor board and disconnect
the brown flex cable (there are two
connections).
9
Lift out the processor board.
10
Remove the black capacitor cable from the
capacitor in the area illustrated.
brown flex cable
Advertising