ZOLL Propaq MD Rev A User Manual
Page 76
Advertising
C
HAPTER
3
D
ISASSEMBLY
P
ROCEDURES
72
9650-0807-01 Rev. A
3
Disconnect the sensor in the area
illustrated.
4
Disconnect the exhaust tube connector
from the air vent at area shown.
Note: Lift both sides at the same time to
pull out.
5
Remove EtCO2 module.
6
Cut the tie wrap holding the NIBP unit.
7
Remove three (3) screws from NIBP unit.
Note: During reassembly, torque screws to
6 in-lbs.
8
Disconnect the four (4) NIBP tubes in the
illustrated locations and remove the NIBP
unit.
NIBP
hoses
Advertising