Removing the monitor board and spo, Modules – ZOLL Propaq MD Rev A User Manual
Page 78
C
HAPTER
3
D
ISASSEMBLY
P
ROCEDURES
74
9650-0807-01 Rev. A
Removing the Monitor Board and SpO
2
Modules
Tool Required
•
# 1 Phillips screwdriver with torque capability
•
Wooden stick
Setup
•
This procedure should be conducted on a static mat.
•
Wear a wrist strap to ground during the procedure.
•
Complete these procedures in the following order before performing this procedure:
1.
“Removing the Handle” on page 61
2.
“Removing the Printer Module” on page 62
3.
“Disassembling the Main Unit” on page 63
4.
“Removing the Front Enclosure Module” on page 66
5.
“Removing the Display Module” on page 68
To reinstall the monitor board and/or SpO
2
modules, reverse the steps.
Monitor Board and/or SpO
2
Disassembly
1
Remove four (4) screws on the right side of
the unit in the illustrated areas.
Note: During reassembly, torque screws to
6 in-lbs.
2
Remove four (4) screws on the left side in
the illustrated areas.
Note: During reassembly, torque screws to
6 in-lbs.
3
Turn the unit over.
shield