ZOLL Propaq MD Rev A User Manual
Page 73
Advertising
Removing the Display Module
9650-0807-01 Rev. A
Propaq MD Service Manual
69
4
Using the 6mm socket wrench, remove the
hex standoff located underneath the screw
you just removed.
Note: During reassembly, torque to
6 in-lbs.
5
Flip the unit back over so the display
screen is facing up.
6
Lift the casting up while pushing down on
the rubber boot that runs around the edge
of the LCD screen.
7
Remove the copper tape from the casting.
Note: During reassembly, apply new
copper tape for grounding.
8
Disconnect the LCD display cable
connectors from the back of the LCD
screen to release it.
hex standoff
boot
copper tape
cable connectors
Advertising