Yokogawa DR240 - Manual (Page 35)

4-6 IM DR231-11E
4.4 Setting the IP Address
Before connecting to the network, you will set the IP address, subnet mask, and default gateway of
the DR. There are two methods in setting these parameters.
Configure from the SET menu of the DR
Configuring from the PC
To configure from the PC, you will need the Data Acquisition Software 32 that came with the DR or
the Data Acquisition Software 32 Plus that is sold separately.
Configuring from the SET menu of the DR
Set the IP address, subnetmask, and default gateway from the SET menu of the DR. After setting
these parameters, the DR restarts. Please note that changing these parameters while the measure-
ment is in progress all previous connection are cleared and stops the measurement.
You can set these parameters even if the mode is set to communication mode.
Configuration procedures
1. Turn ON the DR after inserting the Ethernet module into the DR.
2. Press the “SET” key for about three seconds to go to the SET3 menu.
3. Press either the “
” key or the “ ” key to display “SET=TCP/IP.” Pressing the “ENTRY”
key displays “IP=
ЧЧЧ.ЧЧЧ.ЧЧЧ.ЧЧ
.”
4. Set the IP address. Use the “ ” and “ ” keys to select numbers and “ ” and “ ” keys to
move between digits. Press the “ENTRY” key when you are finished. “SNM=
ЧЧЧ.ЧЧЧ.ЧЧЧ.ЧЧЧ
”
is displayed.
5. Set the subnet mask. The procedure is the same as setting the IP address. Press the “ENTRY”
key when you are finished. “DEF_GW SET=YES” is displayed.
6. Set whether or not to use the default gateway. Press the “ ” key or the “ ” key to select
“YES” or “NO,” and then press the “ENTRY” key.
If you select “NO,” “TCP/IP=YES” is displayed. Continue to step 8.
If you select “YES,” “DEF_GW=
ЧЧЧ.ЧЧЧ.ЧЧЧ.ЧЧЧ
” is displayed.
7. Set the default gateway. The procedure is the same as setting the IP address. Press the “ENTRY”
key when you are finished. “TCP/IP=YES” is displayed.
8. Select whether or not to keep the new configuration. To keep the configuration select “YES.” To
reconfigure select “NO.” Use the “ ” and “ ” keys to select “YES” or “NO.”
If you select “YES,” the DR restarts after you press the “ENTRY” key.
If you select “NO”, “SET=TCP/IP” is displayed after you press the “ENTRY” key. Reconfigure
the parameters from step 4.