Yokogawa DR240 - Manual (Page 82)

7-6 IM DR231-11E
7.5 Setting Data Output Format (Setup mode)
The setup mode parameters are output in the following order by the TS9 + “Device Trigger
(GET)” + LF command:
XA Setting data for alarm
XI A/D integration time setting data for the last unit
XD Setting data for energizing/deenergizing the first
relay
Setting data for energizing/deenergizing the last
relay XD
XB
XB
XJ
XJ
EN
Burnout setting data for the first channel
Burnout setting data for the last channel
Reference junction compensation setting data for
the last channel
Reference junction compensation setting data for
the first channel
Output completion
CrLf
CrLf
CrLf
CrLf
CrLf
CrLf
CrLf
CrLf
CrLf
XI CrLf
CrLf
CrLf
CrLf
CrLf
CrLf
CrLf
CrLf
A/D integration time setting data for the first unit
XQ Setting data for filter on/off
Setting data for reflash relay 1 XY
XY
XN
XN
XH
XV
Setting data for reflash relay 6
AND/OR setting data for the relay in the first unit
AND/OR setting data for the relay in the last unit
Setting data for a hold/non-hold of the relay
Setting data for measurement interval
XR Setting data for for measurement period CrLf
CrLf XK Setting data for a key lock
XC
XC
Dot printing color setting data for the first channel
Dot printing color setting data for the last channel
CrLf
CrLf
CrLf XF Setting data for the function screen
CrLf XS Setting data for the setting screen
CrLf XT Setting data for the temperature unit
CrLf XG Setting data for computation error
Channel numbers are output in the order of input channels and computation channels. For
example, when LF005 and A10 are set, the data are output starting from the input channel 005 to
the last input channel. Then, the data are output starting from computation channels A01 to A10.
Data are output in the order of setting parameters subsequent to the setting command. Each data
item is delimited with a comma (,).
Range of outputting
If output data are issued on a unit or slot basis, the number of units or slots to which the data are
output is determined by specified channels. For example, if channels 042 to 236 are specified by
the LF command, data from slot 4 of subunit 0 to slot 3 of subunit 2 are output.
Note
• Data which are output for burnout and reference junction compensation are those of the channel up to the maximum
number connected for every subunit in the specified range.
• Data which are output for the A/S integration time and AND/OR of relays are those of connected channels.
• Data which are output for energizing/deenergizing relays are output on the basis of the unit to which the module is
connected.
• The data of XH command and XY command are output only when DI/DO module or alarm output module is mounted to
DR230/DR240.
• “S” as data of XN command is meaningless.